Gases burning at high temperature provide a flame strong enough to cut metals. This technology is known as gas cutting.
Different methods used in gas cutting:
- Oxy-gas flame cutting,
- Air carbon-arc cutting,
- Plasma-arc cutting.
The method to be used usually depends on the different type of metals to be cut. As a hardened element, the oxygen and the air carbon tools have the most similar types of element in them. Here are some points to serve as gas cutting guide:
- The oxy gas cutting method has several uses in steel element work. It is mostly utilized in the marine works. All the workers who use this element find it a brilliant tool for cutting different types of sheets made of soft and hard metals. This flexible tool is used for a number of operations like beveling the plate, cutting and rounding pipe, and piercing hole in aluminum and steel plates. When you use the oxy gas cutting process, it helps to heat up the entire metal to the high ignition temperature. This oxy gas flame cutter is known by the term pre-heater cutter.
- Next, you get a jet cutter that changes the heated metal by burning a handle on the cutting machine. The oxygen used in the gas cutter performs the chemical reaction known as oxidation. When oxidation occurs very quickly, it is also known as the combustion or burning of the element. When the same oxidation happens very slowly it is known as rusting.
- During gas cutting, only a certain proportion of the metal gets oxidized. The narrow slits that get formed on the metals are known as the kerfs. Most of the material is removed out from this kerfs portion. The kerfs are actually a form of oxides of metals that are used in oxidation.
- The remaining portion of these materials turns into a molten soft metal, which is blown out of the kerfs by the power of the oxy gas jet.
During gas cutting the ferrous oxide forms the walls of these kerfs and many other metals. These metals should have a smooth and similar texture to each other, after all the developing skills.
Four basic steps to know about the gas-cutting guide:
These four steps are divided into two types. The first two steps involve the standard pressures and the normal cutting speeds, and the other two are used with high pressures and at high cutting speeds.
Four basic steps to know about the gas-cutting guide:
These four steps are divided into two types. The first two steps involve the standard pressures and the normal cutting speeds, and the other two are used with high pressures and at high cutting speeds.
- Standard pressure and fine standard are the two different steps that are applied in the standard pressure (SP) method. The SP element is a one-piece typical weight tip that is used for cutting different materials like wood and metals by hand, especially by welders who are more familiar to all the one-piece tips.
- The fine standard tips can be used more in situation where gases are used as the fuel gas. The fine standard tip is a two-piece element, which has a fine SP line. It is used for cutting elements by hand as well as by the gas cutter machine.
Conclusion:
According to basic gas cutting guide you must take into consideration different aspects. There are various points that are involved in the process and you should remember all of them. The managers or the engineers who have the responsibility of looking after the gas cutting process divide the main work. It is very important to keep a watch on the oxy fuel gas cutting machine. There are differences in the design of the tip and the large roller in it that is used in cut output and quality.
According to basic gas cutting guide you must take into consideration different aspects. There are various points that are involved in the process and you should remember all of them. The managers or the engineers who have the responsibility of looking after the gas cutting process divide the main work. It is very important to keep a watch on the oxy fuel gas cutting machine. There are differences in the design of the tip and the large roller in it that is used in cut output and quality.
0 comments
Note: only a member of this blog may post a comment.